H35-560 by Huawei Valid Free Exam Practice Test

Question 1

Which of the following factors affect the theoretical peak of LTE cells? (multiple choice)

A. MIMOmodel B. UEability C. Communitybandwidth D. Modulation(MCS)

Correct Answer: A,C,D

Question 2

During the test, the bit error rate below 20% is normal.

A. False B. True

Correct Answer: A

Question 3

Regarding indoor distribution antennas and components, which of the following statement is wrong?

A. Attenuator: consuming the excessive energy of RF signal, mainly used to reduce signal level and avoid the influence of overflow B. Power splitter: Split one signal into two or more channels (three-way, four-way) output C. The leaky cable can be regarded as a kind of slot antenna, suitable for coverage in tunnels, subways, etc. D. Try to use "high power, less antenna" for indoor antenna layoutcorrect

Correct Answer: D

Question 4

Which of the following statements about LTE tools is correct? (Multiple Choice)

A. OMStar can be used for network verification B. PRS can be used for simulation and base station selection C. M2000 can be used to configure the network and check the message system. D. Probe can be used for road test and playback

Correct Answer: A,C,D

Question 5

Which of the following are the design principles of LTE tracking area? (Multiple choice)

A. When a UE in an idle state needs to be paged, it must be paged in all cells in the tracking area where the UE is registered B. In the LTE system, the location update signaling caused by the location change should be minimized C. A base station can only belong to one tracking area D. When the UE is in an idle state, the core network can know the tracking area where the UE is located E. The concept of keeping the same tracking area for the LTE access network and core network

Correct Answer: A,D,E

Question 6

In the process of LTE network optimization, which of the following data sources are used for problem location analysis? (multiple choice)

A. Traffic statistics and alarm data B. Signaling data C. Project Files D. netNetwork test data E. useUser complaint record

Correct Answer: A,B,D,E

Question 7

The uplink interference problem is judged by checking the RSRP of each cell.

A. False B. True

Correct Answer: A

Question 8

The drive test scenario judges the success of the handover, usually based on the signaling. On the terminal side, which of the following signaling starts the handover process?

A. Handover Request B. Handover Command C. Measurement Report D. Measurement Control

Correct Answer: C

Question 9

Which of the following results can be reported in the Measurement Report? (Multiple choice)

A. RSSI B. RSRQ C. SINR D. RSRP

Correct Answer: B,D

Huawei HCIA-LTE-RNP&RNO V1.0 - H35-560 Exam Practice Test