Jul 28, 2023 Step by Step Guide to Prepare for HPE0-V14 Exam BrainDumps
HPE ATP - Hybrid IT Solutions V2 HPE0-V14 Real Exam Questions and Answers FREE Updated on 2023
NEW QUESTION # 170
You need to install 10 HPE ProLiant servers in an environment without DHCP.
Which tool can you use to set up remote management?
- A. UEFI System Utilities
- B. iLO 5 Configuration Utility
- C. Intelligent Provisioning
- D. Intelligent Management Center
Answer: D
NEW QUESTION # 171
A customer needs to enable HPE Proactive Care and automated case creation for server hardware failures in their OneView environment.
Which step do you need to complete in OneView to accomplish these tasks?
- A. Configure proactive scan reports.
- B. Enable remote support from the Settings page.
- C. Add the hosts to the managed devices group.
- D. Apply the OneView Advanced monitoring license.
Answer: B
NEW QUESTION # 172
A customer needs a single, dual-processor server for an Enterprise Resource Planning solution for a single office. The customer application uses a mix of HDDs and SSDs and up to 3TB of RAM.
Which HPE Solution should you propose?
- A. HPE ML350 Gen10
- B. HPE ML110 Gen10
- C. HPE Apollo 2000 Server
- D. HPE Synergy Solution
Answer: B
Explanation:
Reference: https://h20195.www2.hpe.com/V2/GetPDF.aspx/4AA0-8758ENW.pdf
NEW QUESTION # 173
A customer has requested that you provide them with an architecture and bill-of-materials for a stack of top-of- rack switches. The customer has 34 HPE DL360 servers in the rack, each with four 1GBASE-T Ethernet ports which need to be connected to the network.
The customer is upgrading 50% of the 1GBASE-T Ethernet ports on the servers to 10GBASE-T Ethernet ports and needs the switching to support the upgraded servers. They are opposed to a chassis switch, and want to keep thei number of managed devices on the network to a minimum.
Which architecture meets the customer requirements?
- A. One IRF stack of four HPE 5710 48-port 1/10GBASE-T switches
- B. Two VSX stacks of two Aruba 8320 48-port 1/10GBASE-T switches
- C. One VSX stack of four Aruba 8320 48-port 1/10GBASE-T switches
- D. Two IRF stacks of two HPE 5710 48-port 1/10GBASE-T switches
Answer: C
NEW QUESTION # 174
Match each adapter to its characteristic.
Answer:
Explanation:
NEW QUESTION # 175
Match the characteristic to the correct HPE ProLiant family.
Answer:
Explanation:
Explanation
ML,DL,DL,ML
NEW QUESTION # 176
A customer needs a new VMware environment for a critical stock trading application and will need high performance compute and low latency storage.
Identify the correct component configurations on the left and drag them to the answer area on the right. (Choose two.)
Answer:
Explanation:
1 - Two HPE DL380 Gen10 servers with two Intel Xeon-Platinum 8270..........
2 - HPE Nimble AF20 with 11TB storage,and dual port 10GbE NIC
NEW QUESTION # 177
A customer wants to install an HPE Proliant server that has a single dual port 10Gb NIC.
Which NIC feature should you introduce to allow each 10Gb port to be seen as four individual adapters in the operating system?
- A. RDMA
- B. NPAR
- C. FCoE
- D. RoCE
Answer: B
NEW QUESTION # 178
A customer environment is being managed and monitored with HPE OneView. A review of the OneView log shows that there have been several trap storm events.
Which series of events must take place for OneView to insert a Trap Storm event entry into the log of system events?
- A. SNMP traps from three or more identical hosts have been logged within the past 256 seconds.
- B. Four or more identical SNMP traps have been logged within the past 30 seconds.
- C. Four or more ports on the same network switch have reported sequential SNMP trap messages
- D. Three or more SNMP trap messages have been logged with increasingly critical variable string values.
Answer: B
NEW QUESTION # 179
A customer is considering an upgrade of their networking infrastructure with HPE FlexFabric 5940 series switch.
Match the fan tray option with the airflow direction.
Answer:
Explanation:
NEW QUESTION # 180
A customer needs a new environment to support an ERP system. The sizing information you received shows the following requirements:
3 servers with dual AMD processors, 256GB RAM, and 10Gb network connectivity
10TB of high performance shared storage
Cloud-based performance monitoring and analytics
The customer prefers rack mounted equipment.
Identify the components that will meet the customer requirements, then drag the correct components on the left to their appropriate location in the environment on the right.
Answer:
Explanation:
NEW QUESTION # 181
A customer is subject to regulatory requirements and their data is highly sensitive.
Which HPE Smart Array feature addresses their need for an level of security for data stored inside their server?
- A. Rapid Parity Initialization
- B. SmartCache
- C. Secure Encryption
- D. Smart Battery backed-up write-cache
Answer: C
NEW QUESTION # 182
A customer environment is being managed and monitored with HPE OneView. A review of the OneView log shows that there have been several trap storm events.
Which series of events must take place for OneView to insert a Trap Storm event entry into the log of system events?
- A. SNMP traps from three or more identical hosts have been logged within the past 256 seconds.
- B. Four or more identical SNMP traps have been logged within the past 30 seconds.
- C. Three or more SNMP trap messages have been logged with increasingly critical variable string values.
- D. Four or more ports on the same network switch have reported sequential SNMP trap mesages
Answer: B
NEW QUESTION # 183
A customer has a single ProLiant DL580 Gen10 running ESXI 7.0. They want to remotely power on the server.
Which locally available management tool should they use to complete this task?
- A. ILO Amplifier Pack
- B. HPE Composer
- C. ILO Advanced
- D. HPE Oneview standard
Answer: C
NEW QUESTION # 184
Match each workload profile description with the corresponding profile. (Select all that apply.)
Answer:
Explanation:
NEW QUESTION # 185
You are configuring an MSA 2052 for one of your customers in OCA.
Click on either one of the two places on the Bill of Materials screen that will enable you to verify the configuration and get details on any errors.
Answer:
Explanation:
NEW QUESTION # 186
Match each workload profile description with the corresponding profile. (Select all that apply.)
Answer:
Explanation:
NEW QUESTION # 187
You are configuring an MSA 2052 for one of your customers in OCA.
Click on either one of the two places on the Bill of Materials screen that will enable you to verify the configuration and get details on any errors.
Answer:
Explanation:
NEW QUESTION # 188
A customer requires a management solution that will provide email notifications if hardware errors occur on their servers.
Which management solution provides this functionality?
- A. HPE SUT
- B. UEFI System Configuration
- C. iLO Advanced Edition
- D. HPE SUM
Answer: C
Explanation:
Explanation/Reference: https://support.hpe.com/hpesc/public/docDisplay?docLocale=en_US&docId=emr_na- a00026111en_us
NEW QUESTION # 189
Which backup targets are available from an HPE StoreOnce backup system? (Choose two.)
- A. Catalyst
- B. VTL
- C. NVMe
- D. S3
- E. iSCSI
Answer: A,B
Explanation:
Reference: https://support.hpe.com/hpesc/public/docDisplay?docId=emr_na-c03824941
NEW QUESTION # 190
Match each HPE solution to its corresponding technology usage.
Answer:
Explanation:
Explanation
NEW QUESTION # 191
Refer to the exhibit.
Drag the correct protocols from the left to the appropriate area on the topology on the right.
Answer:
Explanation:
NEW QUESTION # 192
Refer to the exhibit.
You are designing a new Nimble AF40 for your customer. The array will be added into an existing Nimble HF60 environment connected with SN6000B switches. You have created the configuration shown in the exhibit and noticed an error What should you change in your configuration to ensure it meets the customer requirements?
- A. Change the 10GbE Optical ports to 10BaseT.
- B. Change the controller to an HF20H.
- C. Change the 10GbE Optical ports to Fibre Channel.
- D. Change the controller to an AF20.
Answer: B
NEW QUESTION # 193
ou are designing a system for a customer that runs an OLTP application. The customer has SAN based storage. They need to accelerate application performance.
Which HPE ProLiant Gen10 feature set will address this customer's needs?
- A. CNSA suite
- B. intelligent provisioning
- C. intelligent system tuning
- D. scalable persistent memory
Answer: C
NEW QUESTION # 194
......
Ultimate Guide to Prepare HPE0-V14 Certification Exam for HPE ATP - Hybrid IT Solutions V2: https://www.examslabs.com/HP/HPE-ATP-Hybrid-IT-Solutions-V2/best-HPE0-V14-exam-dumps.html
HPE0-V14 Ultimate Study Guide: https://drive.google.com/open?id=1YwkbzSNb3FtDNbhfx-neah6Pm-zXFDgR