CWNA-108 PDF Dumps Real 2022 Recently Updated Questions
Released CWNP CWNA-108 Updated Questions PDF
Exam Prerequisites
This CWNA-108 test does not have any prior demands, but there is a recommendation concerning the earning of the CWS (Certified Wireless Specialist) or the CWT (Certified Wireless Technician) certificates as they offer the appropriate wireless technology foundational skills for all aspiring applicants.
NEW QUESTION 46
AP-1 is a 3x3:2 AP. STA-3 is a 3x3:3 client. What is the maximum number of spatial streams that can be used for a downlink HT-OFDM transmission from AP-1 to STA-3?
- A. Three spatial streams, because the definition of the client indicates that it is capable of only three spatial streams.
- B. Three spatial streams, because the definition of the AP indicates that it is capable of only three spatial streams.
- C. Two spatial streams, because the definition of the AP indicates that it is capable of only two spatial streams.
- D. One spatial stream, because the definition of the AP indicates that it is capable of only one spatial stream.
Answer: C
NEW QUESTION 47
What statements about the beamwidth of an RF antenna are true?
- A. When antenna gain is lower, the beamwidth is also lower in both the horizontal and vertical dimensions.
- B. Vertical beamwidth is displayed (in degree) on the antenna's Azimuth chart.
- C. The beamwidth patterns on an antenna polar chart indicate the point at which the RF signal stops propagating.
- D. Horizontal and vertical beamwidth are calculated at the points in which the main lobe decreases power by 3 dB
Answer: D
NEW QUESTION 48
During a post-implementation survey, you have detected a non-802.11 wireless device transmitting in the area used by handheld 802.11g scanners. What is the most important factor in determining the impact of this non-802.11 device?
- A. Channel occupied
- B. Airtime utilization
- C. Receive sensitivity
- D. Protocols utilized
Answer: B
Explanation:
Airtime Utilization is a per-channel statistic that defines what percentage of the channel is currently being used, and what percentage is therefore free. Airtime usage can come from: Data traffic to and from client devices. Interference from WiFi and non-WiFi sources. Management overhead from APs and client devices. https://wyebot.com/2019/06/06/understanding-airtime-utilization/
NEW QUESTION 49
When using a spectrum to look for non Wi-Fi interference sources, you notice significant interference across the entire 2.4 GHz band (not on a few select frequencies) within the desktop area of a users workspace, but the interference disappears quickly after just 2 meters. What is the most likely cause of this interference?
- A. USB 3 devices in the user's work area
- B. Excess RF energy from a nearby AP
- C. Unintentional radiation from the PC power supply
- D. Bluetooth devices in the user's work area
Answer: C
NEW QUESTION 50
What wireless networking term describe the increase of RF energy in an intentional direction with the use of an antenna?
- A. Directed Radiation
- B. Active Amplification
- C. Beam Digression
- D. Passive Gain
Answer: D
NEW QUESTION 51
A client complains of low data rates on his computer. When you evaluate the situation, you see that the signal strength is -84 dBm and the noise floor is -96 dBm. The client is an 802.11ac client and connects to an 802.11acAP. Both the client and AP are 2x2:2 devices.
What is the likely cause of the low data rate issue?
- A. Weak signal strength
- B. Lack of support for 802.11n
- C. Too few spatial streams
- D. CAT5e cabling run to the AP
Answer: A
NEW QUESTION 52
Which one of the following frequency ranges is not specified for use by IEEE 802.11 radios as of
802.11-2012?
- A. 5.725-5.874 GHz
- B. 2.4000-2.4835 MHz
- C. 5.15-5.25 GHz
- D. 600-630 MHz
Answer: D
NEW QUESTION 53
During a post-implementation survey, you have detected a non-802.11 wireless device transmitting in the area used by handheld 802.11g scanners. What is the most important factor in determining the impact of this non-802.11 device?
- A. Channel occupied
- B. Airtime utilization
- C. Receive sensitivity
- D. Protocols utilized
Answer: B
Explanation:
Explanation/Reference:
NEW QUESTION 54
Your manager asked you to locate a solution that allows for centralized monitoring of WLAN performance over time. He wants a single pane of glass for administration and monitoring of the solution. What do you recommend?
- A. Overlay WLAN monitoring solution
- B. AP-based spectrum analysis
- C. Laptop-based protocol analyzers
- D. Laptop-based spectrum analyzers
Answer: A
NEW QUESTION 55
You are implementing a VHT-capable AP. Which one of the following channels is available in the 802.11-2016 standard that was not available before the ratification of 802.11 ac?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION 56
Which of the following frequency ranges are specified for use by IEEE 802.11 radios? (Choose all that apply.)
- A. 902 - 928 MHz
- B. 2.4000 - 2.4835 GHz
- C. 5.470 - 5.725 GHz
- D. 5.725 - 5.875 GHz
- E. 5.15 - 5.25 GHz
Answer: B,C,D,E
NEW QUESTION 57
What distinguishes an independent basic service set (IBSS) from an infrastructure basic service set (BSS)?
- A. An IBSS does not require beacon frames, but a BSS does.
- B. An IBSS does not support any 802.11ac enhancements, but a BSS does.
- C. An IBSS does not support 802.11 authentication or association, but a BSS does.
- D. An IBSS does not have a distribution system (DS), but a BSS does.
Answer: D
NEW QUESTION 58
What information is transmitted in the Beacon management frames of an HT access point to communicate about backward compatibility with ERP and HR/DSSS stations? (Choose 2)
- A. HT Protection mode
- B. Non-ERP Present field
- C. RIFS mode
- D. Power save mode of clients
- E. Secondary channel offset
Answer: A,E
NEW QUESTION 59
When implementing PoE, what role is played by a switch?
- A. Midspan injector
- B. Power splitter
- C. PO
- D. PSE
Answer: D
NEW QUESTION 60
What is primary metric of scanning can stations use to select the best AP for connectivity to the desired BSS?
- A. FCS errors in frames transmitted to and from the AP.
- B. Signal strength of access point beacons received
- C. PING latency when testing against an internet server
- D. Throughput speed in Mbps.
Answer: B
NEW QUESTION 61
What terms accurately complete the following sentence?
The IEEE 802.11-2012 standard specifies mandatory support of the ___________ cipher suite for Robust Security Network Associations, and optional use of the ___________ cipher suite, which is designed for use with pre-RSNA hardware.
- A. RC5, RC4
- B. 802.1X/EAP, WEP
- C. CCMP, TKIP
- D. TLS, SSL
Answer: C
NEW QUESTION 62
What is always required to establish a high quality 2.4 GHz RF link at a distance of 3 miles (5 kilometers)?
- A. Minimum output power level of 2 watts
- B. Grid antennas at each endpoint
- C. A Fresnel Zone that is at least 60% clear of obstructions
- D. A minimum antenna gain of 11 dBi at both endpoints
Answer: C
NEW QUESTION 63
What statement accurately describes the RF cables and connectors that are used in an
802.11 WLAN system?
- A. Two RF connectors of the same type (e.g. SMA), manufactured by different companies, may vary in specifications.
- B. Large diameter RF cables cause greater loss than small diameter cables.
- C. Some RF connectorsdo not cause insertion loss.
- D. 75 and 125 ohms are the typical impedances of 802.11 WLAN connectors.
Answer: A
NEW QUESTION 64
Your consulting firm has recently been hired to complete a site survey for a company. Your engineers use predictive modeling software for surveying, but the company insists on a pre- deployment site visit.
What task should be performed as part of the pre-deployment visit to prepare for a predictive survey?
- A. Install at least one AP on each side of the exterior walls to test for co-channel interference through these walls.
- B. Evaluatethe building materials at ABC's facility and confirm that the floor plan documents are consistent with the actual building.
- C. Test several antenna types connected to the intended APs for use in the eventual deployment.
- D. Collect information about the company's security requirements and the current configuration of their RADIUS and user database servers.
Answer: B
NEW QUESTION 65
......
Details for CWNA-108
This test has been valid since September 2020 and the vendor doesn’t have any requirements for the exam-takers. However, they would have more chances to pass such an exam if they have previously won the Certified Wireless Specialist or Certified Wireless Technician certifications. By getting these designations prior to taking the official CWNA-108 exam, the candidates would already have the fundamental networking knowledge. As for the particulars of CWNA-108, this test includes 60 inquiries. They are either multiple-answer or multiple-choice types of questions. Also, the candidates will have 90 minutes to answer a minimum of 70% of the total number of questions. In the case of instructors, they should answer 80% of the questions correctly to get the certificate. Once they get it, the certification is valid for 3 years. To know more, CWNA-108 is a proctored exam, which means that the registration will be done by using the Pearson VUE platform. The examinees should follow the instructions mentioned on the platform and pay the registration fee to validate their enrollment. Its value is $225.
Understanding functional and technical aspects of CWNA® - Certified Wireless Network Administrator Business Principles and Practices
The following will be discussed in CWNP CWNA-108 exam dumps:
- Throughput testing
- Locate and identify sources of RF interference (CHAPTER 12)
- Identify RF disruption from 802.11 wireless devices including contention vs. interference and causes/sources of both including co-channel contention (CCC), overlapping channels, and 802.11 wireless device proximity
- Use of spectrum analyzers for validation tasks
- Understand basic security enhancements of encryption and integrity in WPA3 (e.g. CCMP, GCMP, AES)
- Simultaneous Authentication of Equals (SAE) in WPA3 as an enhancement for legacy pre-shared key technology
- Understand and use the basic features of validation tools (CHAPTER 12)
- Network and service availability
- Understand interference mitigation options including removal of interference source or change of wireless channel usage
- Use of protocol analyzers for validation tasks
- Perform application testing to validate WLAN performance (CHAPTER 12)
- Access control solutions (e.g. captive portals, NAC, BYOD)
- Use of throughput testers for validation tasks
- Protected management frames
- Use of wireless LAN scanners for troubleshooting tasks
- Best practices in secure management protocols (e.g. encrypted management HTTPS, SNMPv3, SSH2, VPN and password management)
- Identify and troubleshoot common wireless issues (CHAPTER 13)
- Use of wireless validation software (specifically survey software and wireless scanners)
- Use of management, monitoring and logging systems for troubleshooting tasks
- Application of AES with CCMP for encryption and integrity
- Identify and solve RF interference using spectrum analyzers
- Use of spectrum analyzers for identifying sources of interference
- Describe and apply common troubleshooting tools used in WLANs (CHAPTER 13)
- Identify and configure effective security mechanisms for enterprise WLANs
- WPA2-Personal including limitations and best practices for pre-shared (PSK) use
- Wireless Intrusion Prevention System (WIPS) and/or rogue AP detection
- Understand basic concepts of WPA3 and Opportunistic Wireless Encryption (OWE) and enhancements compared to WPA2
- Protocol and spectrum analyzers
- Describe common security options and tools used in wireless networks
- Understand the purpose of Opportunistic Wireless Encryption (OWE) for public and guest networks
- VoIP testing
- Identify causes of insufficient throughput in the wireless distribution systems including LAN port speed/duplex misconfigurations, insufficient PoE budget, and insufficient Internet or WAN bandwidth
- Use of protocol analyzers for troubleshooting tasks
- Fast Secure Roaming methods
- Real-time application testing
- Identify sources of RF interference from non-802.11 wireless devices based on the investigation of airtime and frequency utilization
- WPA2-Enterprise -configuring wireless networks to use 802.1X including connecting to RADIUS servers and appropriate EAP methods
CWNA-108 Dumps and Practice Test (178 Exam Questions): https://www.examslabs.com/CWNP/CWNA-Certification/best-CWNA-108-exam-dumps.html
Guide (New 2022) Actual CWNP CWNA-108 Exam Questions: https://drive.google.com/open?id=1umBUBHpRQK5GEzqtTfKgDcTncE4Bkxr-