NS0-502 by Network Appliance Valid Free Exam Practice Test

Question 1

What should you do to verify FC connectivity between the host and the FC switch?

A. check the FC switch for the port type of the host port B. ping the FC switch Ethernet port from the host C. check the FC switch for the WWPN of the host HBA D. check the FC switch for light on the FC port

Correct Answer: C

Question 2

Any newly installed system with Data ONTAP 7.3.1 supports which cfmode?

A. single_image B. mixed C. dual_fabric only D. partner

Correct Answer: A

Question 3

What are two functions provided by the NetApp Host Utilities Kits? (Choose two.)

A. They identify and set path priorities for NetApp LUNs. B. They provide the ability to take snapshots of local file systems. C. They provide SnapMirror/SnapVault integration.ns. D. They provide properly set disk and HBA timeout values.

Correct Answer: A,D

Question 4

What is the default Ethernet packet size (or MTU - Maximum Transmission Unit) for Ethernet ports on Ethernet switches?

A. 1500 bytes B. 2112 bytes C. 9000 bytes D. 12000 bytes

Correct Answer: A

Question 5

Click the Exhibit button.

You see the following error on the storage controller's console or messages file. What is the most likely cause for this error?

A. portal group misconfiguration B. IPsec misconfiguration C. iSCSI CHAP misconfiguration D. iSNS misconfiguration

Correct Answer: C

Question 6

You connect a host to a NetApp storage system through an FC switch. The host has its boot volumes on the NetApp storage system. What is mandatory for you to configure?

A. persistent binding B. portsets C. WWPN zoning D. port zoning

Correct Answer: A

Question 7

Which task is part of the site preparation for installation?

A. install equipment in rack B. configure zoning C. verify equipment move path D. verify host to storage connectivity

Correct Answer: C

Question 8

Zoning by World Wide Port Name (WWPN) is deployed and a host HBA is replaced.
Which zone change needs to be made?

A. The zone configuration should be changed to include the WWPN of the new HBA and to remove the WWPN of the old HBA. B. No changes are necessary. C. The zone configuration should be changed to include the WWPN of the new HBA; the old WWPN will be automatically dropped. D. The zone configuration should be changed to include the port to which the HBA is connected.

Correct Answer: A

Network Appliance NetApp Certified Implementation Engineer - SAN, 7-Mode - NS0-502 Exam Practice Test