NS0-164 by Network Appliance Valid Free Exam Practice Test

Question 1

Which two supported methods would you use to restore data from a SnapVault for Net Backup Volume?

A. Use the snapvault restore Data ONTAP command B. Use the Net Backup Administration Console C. Use drag-and-drop technologies D. Use the SnapRestore Data ONTAP service

Correct Answer: B,C

Question 2

Which two statements are true about ONTAP? (Choose two).

A. ONTAP supports a limited set of application. B. ONTAP offers flexible options such as SSDs, HDDs, and public clouds. C. ONTAP can only be deployed on specific architectures. D. ONTAP supports scalability with additional storage drives and controllers.

Correct Answer: B,D

Question 3

Which two steps should an administrator take to create a two-node ONTAP Select cluster that spans two data centers and provide automated switchover without any data loss? (Choose two.)

A. Use ONTAP Mediator service to make sure that a quorum exists for the two nodes B. Set up a SnapMirror Synchronous relationship in StrictSync mode to prevent any data loss in case of a failover C. Make sure that the ONTAP Select Deploy VM resides at a third location other than the two data centers D. Use ONTAP Select Deploy to install the nodes on the VMware environment

Correct Answer: A,D

Question 4

Fill in the blanks for the following statement:
The qtree specified for_____must not exist on the secondary system before you run the_____command.

A. pri_qtree_path. snapvault start B. sec_qtree_path. snapvault start C. pri_qtree_path. snapvault enable D. sec_qtree_path. snapvault enable

Correct Answer: B

Question 5

Which capacity and parity savings feature is configured at the factory with all AFF systems?

A. RAID4 B. ADP root-data-data C. ADP root-data D. RAID-TEC

Correct Answer: B

Question 6

When adding an FC initiator identifier to an initiator group, which identifier should you use?

A. software initiator iSCSl Qualified Name (IQN). B. host bus adapter (HBA) worldwide port name (WWPN). C. host bus adaptor (HBA) worldwide node name (WWNN). D. Target Portal Group (TPG) tag.

Correct Answer: B

Question 7

When creating an S3 bucket using System Manager, ONTAP uses which default performance service level for an AFF?

A. Performance B. Extreme C. Value D. Custom

Correct Answer: B

Question 8

How can you "throttle" Snap Vault updates and baseline transfers so that the primary or secondary is not transmitting data as fast as it can?

A. None of the above B. Use the -k option in the snapvault start command. C. SnapVault doesnt support throttling of networkthroughput D. Use the snapvault throttle command.

Correct Answer: B

Question 9

Which SVM type owns cluster LIFs?

A. Node B. System C. Admin D. Data

Correct Answer: D

Question 10

The snapvault restore command is ran on the:

A. Secondary system to push data to Open System B. Primary system to pull data from the secondary system C. Primary Open System to pull data from the secondary system D. Secondary system to push data to the primary storage appliance

Correct Answer: B

Question 11

An administrator Is troubleshooting failover to an ONTAP SVM-DR destination cluster. The failover test works but stops replication. The administrator has a requirement to keep SnapMirror replication running while performing the failover test.
What ONTAP feature will accomplish this task?

A. SM-BC B. FlexClone C. SMS D. SnapRestore

Correct Answer: A

Question 12

A NearStore system or storage appliance can operate as a secondary and primary system at the same time.

A. False B. True

Correct Answer: A

Network Appliance NetApp Data Administrator ONTAP Professional - NS0-164 Exam Practice Test