JN0-1361 by Juniper Valid Free Exam Practice Test

Question 1

Exhibit:

Within ISP E, R1 is load-balancing traffic destined to ISP D over the R1-R2-R5 and R1-R4-R5 paths. At some point, a link degradation event occurs in the network as shown in the exhibit. You want R1 to rapidly learn of the path failure.

A. Enable Bidirectional Forwarding Detection between R4 and R5. B. Adjust the OSPF hello timer to a subsecond value between R4 and R5. C. Adjust the OSPF hello timer to a subsecond value between R1 and R4. D. Enable Bidirectional Forwarding Detection between R1 and R4.

Correct Answer: A

Question 2

You are implementing an MPLS-based WAN environment to connect remote sites to the corporate headquarters (HQ) However, the service provider at the HQ location does not provide service at the location of one of the remote sites.
Which statement is true in this scenario?

A. A dedicated leased line will need to be used to connect to the remote site. B. A hub site in a location where both service providers have a presence will need to be deployed. C. A circuit can be bridged across multiple service providers for end-to-end connectivity. D. A public WAN circuit can be provisioned over the Internet that will provide the same level of service.

Correct Answer: C

Question 3

Exhibit:

Referring to the exhibit which statement is true about the connectivity between service provider A and B regarding the customer's network information?

A. The service providers may not be aware that they are providing inter-network routing for the customer. B. The customer is acting as a colocation (meet-me) for an inter-network routing scenario shown in the exhibit. C. The service providers must set up MPLS label exchange between each other for this scenario to work. D. The service providers must set up MP-BGP between each other to support this inter-network routing.

Correct Answer: D

Question 4

You are asked to provide a proposal for a service provider's OSPF network. The customer is concerned about the volume of link-state advertisements within their network and want to limit this traffic.
Given this scenario which design component would satisfy the customer's requirement?

A. Use multiple levels. B. Use multiple areas. C. Use the same router IDs. D. Use the same AS number.

Correct Answer: B

Question 5

Which statement is correct regarding classifiers in CoS?

A. Classifiers are used to separate traffic into different forwarding classes. B. Classifiers are used to change DiffServ values on outgoing packets. C. Classifiers are used to define the transmit rate for forwarding classes. D. Classifiers are used to route traffic between routing instances.

Correct Answer: A

Question 6

Your WAN links are on a VPLS service from a single service provider. You must verify device configuration power and status in the event of a service outage.
Which two actions provide out-of-band management to your edge routers? (Choose two)

A. Place management traffic on a separate VLAN on the VPLS service B. Connect each serial management port to a console server with a cellular Internet connection C. Connect each Ethernet management interface to a dedicated switch with traffic routed on its own subnet on the VPLS service D. Connect each Ethernet management interface to a dedicated switch with its own WAN connection.

Correct Answer: B,D

Explanation: Only visible for ExamsLabs members. You can sign-up / login (it's free).

Question 7

You are asked to design a Cloud CPE solution that can dynamically add new sites to an existing MPLS Layer 3 VPN. The CPE for each new site must support the service chaining of multiple VNFs.
Which Juniper Networks Cloud CPE solution supports these requirements?

A. Distributed Cloud CPE - Managed Internet B. SD-WAN C. Centralized Cloud CPE D. Distributed Cloud CPE - Option 1

Correct Answer: D

Juniper Service Provider Design, Specialist (JNCDS-SP) - JN0-1361 Exam Practice Test