HPE0-S50 by HP Valid Free Exam Practice Test

Question 1

Refer to the exhibit.

Based on the Synergy configuration shown, what will be the outcome in the event of an end-of-row (EoR) switch failure?

A. Uplink bandwidth will decrease. B. Server and downlinks will fail. C. There will be no NIC failover. D. Smartlink will be triggered.

Correct Answer: C

Question 2

A customer has forgotten the password to the HPE Oneview Appliance controlling the customer HPE synergy infrastructure.
Where cans the customer reset the password with the assistance of HPE Support?

A. Virtual Center server B. Maintenance Console screen C. FLM Access to synergy Console D. Front Access panel to Synergy Console

Correct Answer: B

Question 3

A Synergy integrator needs to add more to a server profile.
What does the integrator need to be aware of performing this action?

A. The host needs to be powered off to active the change. B. The host networks will go offline the when the profile is assigned. C. The Virtual Connect modules needs to be reboot once the profile applied. D. The server profile must be changed before modifying the server profile.

Correct Answer: D

Question 4

Use the arrow or click drag steps on the left to set up a new HPE Synergy 12000 Frame into the correct on the right.

Correct Answer:

Question 5

A Synergy Integrator is configuring an HPE Synergy environment with two HPE Connect 40Gb F8 modules.
The Synergy integrator has four 40Gb uplinks connected to two upstream switches and needs all compute modules to share the full 160Gb of available bandwidth. The upstream are interconnected in a virtual port channel (vPC) pair.
What should the integrator do to ensure that the switch configuration doe not result in a network loop?

A. Cross connect the Virtual Connect modules to the upstream switches and select all four 40Gb ports for the uplink Configure spanning tree protocol (STP) on the Virtual Connect uplink to default to port forward mode. B. Create two separate Virtual Connect uplinks. Select one part from each module for each uplink. Use two separate Logical Interconnect Group (LIGs) to keep the uplinks from looping. C. Cross Connect the Volume Connect modules to the upstream switch and select all four 40Gb ports for the uplink Virtual Connect will automatically configure the Multiple Link Aggregation Group.
(MLAG). D. Create two separate Virtual Connect uplinks Select two ports from each module fro each uplink.
Configure spanning three protocol (STP) on both Virtual Connect uplinks to default port forward mode.

Correct Answer: D

Question 6

A customer has moved a USB bootable drive to another compute module but the compute module fails to boot from the USB device.
What should the Synergy integrator do to resolve this issue?

A. In the server Profile. make sure OS Deployment is set to Deployment plan. B. Verify that the USB drive key is enable in UEFI system Utilities. C. Make sure PXE boot is disabled. D. Use UEFI System Utilities to disable the B1401 RAID controller.

Correct Answer: D

HP Integrating HPE Synergy Solutions - HPE0-S50 Exam Practice Test