DCAPE-100 by Dell Valid Free Exam Practice Test

Question 1

A server arrives without any RAID configuration. All firmware is up to date. The server has a PERC H730p controller. The technician needs to configure the required RAID arrays prior to OS installation.
Which three methods can be used to configure the RAID arrays? (Choose three.)

A. Access the Physical Disk section of the iDRAC GUI B. Boot into the F2 BIOS C. Access the Virtual Disk section of the iDRAC GUI D. Boot into the Ctrl+C E. Boot into the Ctrl+R

Correct Answer: B,C,E

Question 2

A server has two 1100w power supplies. The system needs to enable or disable power supplies dynamically depending on power needs. Power Supply 2 needs to be main power supply.
Which two settings should the technician change? (Choose two.)

A. Enable Hot Spare for power supplies B. Set Power Cap to 1100w for the system C. Set Primary Power Supply to PSU 2 D. Enable Power Factor Correction E. Set Default Power Supply to PSU 2

Correct Answer: A,C

Question 3

A technician deploy a new server in a datacenter and must install Microsoft Windows Server 2012 R2.
Which two steps are required to install the OS using the Lifecycle Controller? (Choose two.)

A. Restore server profile B. Configure storage C. Place OS media in DVD attached to server D. Disable iDRAC virtual media E. Configure Lifecycle Controller network settings

Correct Answer: A,D

Question 4

A technician needs to initially configure a server from a bare metal condition in the following areas:
* Processor settings
* Disk configuration
* iDRAC network settings
The technician can only reboot once to achieve these tasks.
Where should the technician configure these settings? (Choose three.)

A. PERC Configuration Utility B. Device Settings C. System BIOS D. PXE Settings E. iDRAC Settings

Correct Answer: A,C,D

Question 5

A technician needs to configure a server to PXE boot a server setup image with the BIOS in UEFI mode.
Which two steps should the technician perform to enable this function? (Choose two.)

A. Navigate to Network Settings, PXE Device1 Settings, and configure IP. B. Navigate to Boot Options Settings and set PXE Device1 as first option. C. Boot to Ctrl+S and configure the NIC for PXE Device1. D. From the iDRAC web interface, select Network Settings, and enable PXE Device1. E. From System Setup Utility, choose Device Settings. Configure NIC for PXE.

Correct Answer: B,C

Question 6

A technician configures iDRAC on a new server for access on the management network.
When accessing via telnet, the connection is refused. Network connectivity is a verified network. NO ports are blocked by any network devices.
Why is the telnet connection being refused?

A. Telnet is NOT enabled by default on the iDRAC B. The telnet client must be configured to connect to port 8899 on the iDRAC C. Telnet is NOT supported to access iDRAC. D. The iDRAC must be configured to allow the IP address of the technician's workstation.

Correct Answer: A

Dell PowerEdge Associate - DCAPE-100 Exam Practice Test