9L0-006 by Apple Valid Free Exam Practice Test

Question 1

You are troubleshooting an eMac that has no image on its built-in display. You have already checked user controls and reset PRAM, but the issue persists. When you connect an external display to the eMac's VGA output port and restart the eMac, you see a proper image on the external display. Which of the following service modules would most likely be the cause of these symptoms?

A. Display Analog Assembly B. Logic Board C. Hard drive D. Power Supply Assembly

Correct Answer: A

Question 2

Which of the following is NOT a good step to take when working onsite on a computer?

A. Use a grounded ESD mat. B. Check the polarity of the grounded power outlet. C. Wear a grounded ESD wrist strap. D. Place parts on the floor.

Correct Answer: D

Question 3

Which THREE of the following symptoms would be most likely resolved by performing a
SMC reset as a first step? SELECT THREE

A. Computer does not turn on B. USB and/or FireWire port(s) do not function C. Cursor is unresponsive in Finder D. Computer does not sleep / wake from sleep E. Network / Internet connectivity issues

Correct Answer: A,B,D

Question 4

Which THREE of the following components should you be very careful with, when working inside an Apple portable? SELECT THREE

A. Ribbon cable B. Deflection coil C. Flyback transformer D. Anode aperture E. Small screw F. Plastic tab

Correct Answer: A,E,F

Question 5

Which of the following PowerBook G4 models does NOT support hot-swapping the main battery?

A. PowerBook G4 (12-inch) B. PowerBook G4 (15-inch) C. PowerBook G4 (17-inch)

Correct Answer: A

Question 6

Where is the best place for a customer to look for information about upgrading his Mac Pro's hard drive?

A. Downloads B. Apple DIY website C. Discussions D. Service manual

Correct Answer: B

Question 7

Which of the following is NOT a valid power saving technique in recent Macintosh computers?

A. Use wireless networks instead of wired networks. B. Activate automatic hard disk sleep. C. Activate automatic display sleep. D. Set up locations optimized for different environments. E. Quit all the communications applications that may use the modem.

Correct Answer: A

Question 8

A Mac Pro fails to start up, and the status light on the front of the computer flashes three times. What does this indicate?

A. A RAM bank failed memory testing B. Thermal failure C. Firmware v3.0 upgrade required D. No startup disk found

Correct Answer: A

Question 9

On a MacBook Pro, Safe Sleep ensures that _____.

A. the user is prompted to save documents in any open applications before machine is put to sleep using the Sleep command from the Apple menu B. data stored in main memory will not be lost should the system shut down due to power loss while the machine is asleep C. any open IP ports from services are closed before putting the machine to sleep D. the machine is locked with a configured password after a specified amount of time

Correct Answer: B

Question 10

Which of the following safety issues applies to the iMac (Mid 2007)?

A. Fragile glass panel breakage B. Thermal grease toxicity C. Liquid coolant spillage D. High voltage CRT discharge

Correct Answer: A

Apple Macintosh Service - 9L0-006 Exam Practice Test