642-732 by Cisco Valid Free Exam Practice Test

Question 1

What document is required to build the Statement of Work?

A. post-survey questionnaire B. pre-survey questionnaire C. site survey report D. installation report

Correct Answer: B

Question 2

Which item is the most common limiting factor in an outdoor coverage for mesh deployment?

A. 2.4GHz MAP to RAP backhaul B. 2.4GHz MAP access C. 2.4GHz client D. 5GHz MAP to RAP backhaul

Correct Answer: C

Question 3

When does the curvature of the earth become a factor in an outdoor RF point-to-point link?

A. 15 miles B. 7 miles C. 4 miles D. 10 miles E. 12 miles

Correct Answer: B

Question 4

Which wireless tool would be most useful in planning a WLAN solution prior to performing a site survey?

A. Cisco Spectrum Expert B. Air Magnet Survey C. Cisco WCS D. Air Magnet Wi-Fi Analyzer E. Ekahau Survey

Correct Answer: C

Question 5

What is the biggest challenge a customer faces when they are presented with the post-installation report?

A. Maintaining the security of the report so that only IT personnel have access to the information contained in the report. B. Interpreting the configuration parameters and settings for the WLAN devices. C. Validating the information is correct. D. Maintaining the report so that once the first change to the WLAN is made the documentation remains current.

Correct Answer: D

Question 6

A wireless engineer is gathering equipment to perform a point-to-point bridge survey. What three pieces of equipment should be used? (Choose three.)

A. 1552e with three AIR-ANT2547-N= B. 3502i with dual band directional antennas C. 1142 Series with internal antennas D. 1310 with internal antenna E. 3502e with AIR-ANT2460NP-R F. 1552e with AIR-ANT2588P3M-N= G. 1132 with a 10dBi Yagi

Correct Answer: D,E,F

Question 7

When designing and deploying an outdoor mesh network, what is the appropriate RF cell overlap?

A. 15 percent B. 10 percent C. 25 percent D. 20 percent E. Application dependent

Correct Answer: E

Question 8

For better compatibility with 802.11n clients, which 802.11a channels should be utilized?

A. UNII-2 Band - extended channels B. ISM Band C. UNII-3 Band D. UNII-1 Band

Correct Answer: D

Question 9

Which three reasons describe the importance of assessing existing wired infrastructure? (Choose three.)

A. determine cable length B. determine LWAPP support C. determine CAPWAP support D. determine quality of service E. determine PoE requirement F. determine UPS requirement G. determine port bandwidth

Correct Answer: A,E,G

Question 10

Which two issues do access and backhaul radios experience in mesh networks? (Choose two.)

A. RAPs help MAPs avoid coverage holes. B. The access cell radio range is larger than the backhaul radio range, which causes the backhaul cell radio to suffer from more interference. C. The access cell usually covers more area at ground level that may have more sources of reflection and interference. D. Backhaul radios are a bottleneck for throughput. E. The access radio has to connect to two or several points.

Correct Answer: C,D

Cisco Conducting Cisco Unified Wireless Site Survey (CUWSS) v2.0 - 642-732 Exam Practice Test