RVT_ELEC_01101 by Autodesk Valid Free Exam Practice Test

Question 1

An electrical designer is creating an electrical equipment family which will host conduit that can be modeled from any point on a specific side of the equipment. How should this be accomplished?

A. Select the conduit connector and edit the connector type in the Properties palette B. Click Conduit Connector, click Individual Connector, and then select the desired reference plane. C. Click Conduit Connector click Surface Connector, and then select the desired face. D. Select the conduit connector and edit the connector dimensions

Correct Answer: C

Explanation: Only visible for ExamsLabs members. You can sign-up / login (it's free).

Question 2

Refer to exhibit.

An electrical designer is working m a view set for Phase 3.
Which elements within this view will be overridden according to the "Temporary" graphic override settings?

A. Elements that were created and demolished in Phase 2 B. Elements that were created in Phase 1 and demolished in Phase 3 C. Elements that will be demolished in Phase 4 D. Elements that were created and demolished in Phase 3

Correct Answer: D

Explanation: Only visible for ExamsLabs members. You can sign-up / login (it's free).

Question 3

Refer to exhibit.

An electrical designer expects the total connected load on the switchboard to be 4000VA. but Revit Indicates a total connected load of 3606VA. What Is the cause of the discrepancy?

A. Load is connected through the switchboard's feed through lugs. B. The connected loads are set to a different voltage than the switchboard. C. The Motor demand factor is configured to adjust the connected load. D. Sum true load and reactive load is selected in Electrical Settings.

Correct Answer: C

Explanation: Only visible for ExamsLabs members. You can sign-up / login (it's free).

Question 4

An electrical designer Is working on a workshared model.
Which two worksharing display settings can the designer use to visualize model elements that have no ownership? (Select two.)

A. Model Updates B. Checkout Status C. Worksets D. Gray Inactive Worksets E. Owners

Correct Answer: B,E

Explanation: Only visible for ExamsLabs members. You can sign-up / login (it's free).

Question 5

Exhibit.

An electrical designer is working within a workshared electrical model The designer reloads the linked architectural model and receives the message as shown in the exhibit What does this message indicate?

A. There is a new coordination message within the architectural model. B. A monitored element in the architectural model has changed. C. There is a new interference with the architectural model. D. An elements host within the architectural model has changed.

Correct Answer: B

Explanation: Only visible for ExamsLabs members. You can sign-up / login (it's free).

Question 6

A project is almost at the end of design. The electrical designer needs to make sure electrical loads as reported by load summaries accurately reflect all modeled loads. How should a designer view a list of all modeled electrical connectors that are not connected to a circuit?

A. Use the command Check Circuits. B. Review the System Browser. C. Use the command Show Disconnects. D. Create a circuit schedule.

Correct Answer: C

Explanation: Only visible for ExamsLabs members. You can sign-up / login (it's free).

Question 7

What should an electrical designer do to associate a lighting device with light fixtures in a model?

A. Create a switch system using the light fixtures to define the system and add the switch. B. Create an electrical circuit using the light fixtures to define the system and add the switch. C. Create a switch system by selecting a switch and then adding lights D. Create an electrical circuit including the light fixtures and switch as one selection.

Correct Answer: C

Explanation: Only visible for ExamsLabs members. You can sign-up / login (it's free).

Autodesk Certified Professional in Revit for Electrical Design - RVT_ELEC_01101 Exam Practice Test