HP0-091 by HP Valid Free Exam Practice Test

Question 1

Which command shows all physical volumes in a volume group?

A. lvmdisplay B. vgdisplay C. pvdisplay D. lvdisplay

Correct Answer: B

Question 2

Which file is used for automount configuration?

A. /etc/rc.config.d/nfsconf B. /etc/netconf C. /etc/automount.conf D. /etc/nfsconf

Correct Answer: A

Question 3

Which file is used to configure networking parameters such as hostname, IP address, and subnet mask?

A. /etc/rc.config.d/ipconf B. /etc/rc.config.d/netconf C. /etc/rc.config.d/ifconf D. /etc/rc.config.d/lanconf E. /etc/rc.config.d/network

Correct Answer: B

Question 4

If /tmp is 100% full, which commands are used to determine its volume location and if free space is available on that disk?

A. bdf, lvdisplay, pvdisplay B. bdf, vgdisplay C. vgdisplay, lvdisplay, diskinfo D. lvdisplay, diskinfo

Correct Answer: A

Question 5

What do the vi commands :wq! and ZZ do?

A. writes any changes back to disk and continues in vi B. undoes any changes and stays in vi C. writes any changes back to disk and exits from vi D. cancels any changes made and quits from vi

Correct Answer: C

Question 6

Which system file is used to store information about networks that are connected to the system?

A. /etc/netconfig B. /etc/nettab C. /etc/nic D. /etc/networks

Correct Answer: A

Question 7

How do you set up a device swap area and ensure it is active at each system startup?

A. Start device swapping using theswapon command on a logical volume; add an entry to the /etc/vfstab file. B. Start device swapping using theswapon command on an existing file system mount point. C. Start device swapping using theswapon command on a logical volume; add an entry to the /etc/fstab file. D. Start device swapping using theswapon command on a logical volume; add an entry to the /etc/sbtab file.

Correct Answer: C

Question 8

What happens to swap space when a process is forked?

A. It is assigned. B. It is extended. C. It is created. D. It is reserved.

Correct Answer: D

Question 9

Which statements are true regarding threads and processes? Select TWO.

A. A thread forces the entire process to run on a single set of resources. B. A thread is a component of a process. C. A process is a representation of an entire running program. D. Threads and processes have nothing to do with each other. E. A process is a component of a thread.

Correct Answer: B,C

HP-UX System Administration - HP0-091 Exam Practice Test